Code alarm manual reset

Exit the vehicle close all doors and arm the alarm system Wait 30 seconds, then trigger the alarm by opening a door With the siren sounding enter the vehicle and turn the ignition to the ON position After two (2) seconds the status indicator will begin flashing for Code Entry. Follow the Code Entry Procedure. Meanwhile, an alarm reset is the process of clearing the system following an alarm event. This can be done by simply entering in a valid system user code or the system Master Code. The siren for the system should stop sounding, and the alarm event will be cleared. How to reset Veritas alarm after tamper. Enter your user code and press [RESET]. If this doesn’t work then refer to our ‘ The tamper light is flashing article’ which gives more in-depth reasons as to how to reset your Veritas alarm. Need further help?

Press the ARM button to arm the alarm system. Within 5 seconds, press the ARM button again. The system will respond with three (3) chirps and three light flashes, indicating that the lite-touch feature is disabled. This procedure disables the sensor for only one arm/disarm cycle. The sensor will be enabled the next time the alarm system is armed. Open the access door and enter your master code twice. Pull down the panel that covers the keypad on your alarm system. After this, simply enter your 4 digit master code, wait 2 seconds, and then enter it again. On some models, this step will reset the alarm and stop it from ringing. Here’s how you can reset the alarm via the control panel: Remove the cover. Remove the battery. Press and hold the tamper button. Insert the battery while holding the tamper button. The LED light will flash. Hold the button until it stops flashing. Replace the cover.

code, the internal sounder will stop and revert to a low two tone sound. Press the # key the panel will reset, if the tamper light continues to flash. Upon a fire alarm, the bell/siren will emit three “squawks” at 2 second intervals until silenced or reset by entering a valid user code. To reset the detectors, press and hold the Reset key for two seconds or Customer must know the current master code before programming the user codes.